Basic strip foundation reinforcement:
Following this series, you can see how ALLTO PythonParts work for building reinforcement.
Double click to open the interface for the StripFoudation PythonPart 
get elevation & dimensions for this foundation define parameters in each tab click to Create button.
Basic Hello Allplan! strip foundation – Transverse rebar tab
Now move to the next tab to define parameters for the transverse rebars. In this tab, we can select to create Upin just in bottom or for top and close stirrups.
Basic Hello Allplan! strip foundation – Longitudinal rebar tab
– With these bars, I will define spacing 150mm and diameter 16mm.
Basic Hello Allplan! strip foundation – Side rebar tab
And the next type: side rebars.
With side rebars, I will define 3 bars for each side. And diameter 16mm.
Basic Hello Allplan! strip foundation – starter rebar tab
the last type is starter rebars.
– We have some walls above with the width is 240mm so I input 240 here. ➡️ rebars will be created at the center of the strip with this option ticked.
– For type of starter, we have 4 selections and I will select U pin. ➡️ click to this button to start create reinforcement.
Basic Hello Allplan! strip foundation – section and label tab
we will create section and label for these strip foundation.
Double click and open the interface. ➡️ define parameter for section.
